42
Adjustments
Miter Scale (Vernier) Indicator
Adjustment
1.
Raise the head assembly to the full-up position.
2.
Through the slot
1
in the kerf insert, loosen the Phillips
screw
2
that holds the indicator
3
in place (Figure 14).
3.
Position the indicator
3
to align with the 0° miter mark
4
.
Tighten the screw
2
.
Crown Molding Detent
Adjustment (Bevel)
1.
Move sliding fence to proper position. (See Sliding
Fence on page 54.)
2.
Pull crown molding detent pin out and rotate pin 90° so
it stays in the out position.
Keep pin in out position for all operations
except when cutting crown molding.
3.
Loosen bevel lock handle
5
. Rotate head assembly to
33.9° on the bevel scale. Insert the pin
6
into the detent,
tighten the bevel lock handle
5
(Figure 15).
4.
Measure the angle between the blade and the table. If it
is not 33.9° follow the procedures for the crown molding
detent adjustment.
Crown Molding Detent Adjustment
a.
Remove plastic plug
7
.
b.
Loosen crown molding detent adjusting hex head
cap screw
8
using the 6mm Hex "L" Wrench.
c.
Loosen bevel lock handle
5
.
d.
Move the head assembly, with the pin
6
still
inserted into the detent, to 33.9°.
e.
Tighten bevel lock handle
5
. Tighten adjusting
screws
7
.
40
35
30
25
20
15
10
5
0
5
10
15
20
25
316
225
30
35
40
45
FIG. 14
FIG. 15
2
4
3
1
6
5
7
8
CAUTION
!
