05/20
BBJ50TA
Made in China to TQB Brands Pty Ltd specifications
P a g e
|
5
Visit us at www.tqbbrands.com.au
7.
Insert and secure the handle into handle sleeve. Pump handle or squeeze the lift control valve
until the saddle contacts load. To end air operation simply release the grip on the lift control
valve.
8.
Raise load to the desired height, then immediately transfer the load to appropriately rated jack
stands.
WARNING
Never wire, clamp or otherwise disable the lift control valve to function by any means other than by
using the operator's hand. Use the handle provided with this product or an authorised replacement
handle to ensure proper release valve operation. Do not use extensions on the air hose or on the
operating handle.
To Lower Vehicle:
1.
Raise load high enough to allow clearance for the jack stands to be removed, then carefully
remove jack stands.
2.
Insert handle release valve and slowly turn handle counter clockwise, no more then 1/2 a turn.
3.
Grasp the handle firmly with both hands. Securely hold on to the jack handle so your hands do
not slip and ensure the load does not rapidly lower.
4.
(Do not allow bystanders around the jack or under the load when lowering the jack).
4.
MAINTENANCE
If you use and maintain your equipment properly, it will give you many years of service. Follow the
maintenance instructions carefully to keep your equipment in good working condition. Never
perform any maintenance on the equipment while it is under a load.
Inspection: Inspect the product for damage, wear, broken or missing parts (eg: pins) and that all
components function before each use. Follow lubrication and storage instructions for optimum
product performance. Ensure all moving parts are clear of dirt and debris.
Cleaning: If the moving parts of the equipment are obstructed, use cleaning solvent or another
good degreaser to clean the equipment. Remove any existing rust, with a penetrating lubricant.
Lubrication: This equipment will not operate safely without
proper lubrication. Using the equipment without proper
lubrication will result in poor performance and damage to the
equipment. A coating of light lubricating oil to pivot points,
axles and hinges will help to prevent rust. Periodically check the
pump piston and ram for signs of rust or corrosion. Clean as
needed and wipe with an oily cloth.
NEVER USE SANDPAPER OR ABRASIVE MATERIAL ON THESE SURFACES.
To Add Jack Oil:
NEVER USE BRAKE FLUID, TURBINE OIL, TRANSMISSION FLUID, MOTOR OIL OR GLYCERIN.
IMPROPER FLUID WILL CAUSE PREMATURE FAILURE OF THE JACK AND THE POTENTIAL FOR
SUDDEN OR IMMEDIATE LOSS OF LOAD
1.
With saddle fully lowered and pump piston fully depressed, set jack in its upright level position.
2.
Remove oil filler plug.
Lubricate
Pivots & Pins
(30/40W Machine Oil)
Add Drops
(10ml SAE32 Grade Oil)
or Air Tool Lubricant
