01
B Ø R R E S E N
LO U D S P E A K E R
SERIAL NO.:
10000XXX
MADE IN DENMARK
+
-
R
AMP
SPEAKER OUT
L
P
Q
1. Connect a two-pole (+/-)
loudspeaker cable to the binding
posts, located at rear of the
loudspeaker
P
.
The high quality binding posts
can accommodate only 4-mm-
plugs (“banana plugs”).
The pins can be put directly into
the binding post without any
tightening necessary.
Note:
• With every connection system, ensure that the contact is tight and
has a proper contact area.
• Connectors with gold plating will typically offer the best results
and remain corrosion-free.
• Please ensure that the positive and negative cables do not make
contact with each other.
• Check the connectors from time to time to make sure that nothing
has loosened.
2. Connect the other cable ends to the loudspeaker outputs of your switched off power amp
Q
Note: Please make sure that both loudspeakers are connected properly.
Connecting the loudspeakers
CAUTION
Distorted output signals from too weak, defective or
overloaded amplifiers may damagethe loudspeakers.
• Use high quality amplifiers only and run loudspeakers
and amplifiers within specified power ratings.
9