BorMann BWR5074, Руководство пользователя

Страница: 2 / 6

EN
WWW.BORMANNTOOLS.COM
2
Read the Manual and warnings on the stacker before using it.
NOTE: All of the information reported herein is based on data available at the
moment of printing. We reserve the right to modify its own products at any moment without notice and incurring in any sanction. So, it is suggested to always
verify possible updates.
Structure & mechanism
The stacker is composed of hydraulic system and mast.
This stacker hoists weight with manual hydraulic jack and hauls loads by manual force.
The hydraulic gear is equipped with spill valve and descent lever to control forks lowering rate and ensure the hydraulic action accurate and reliable.
The framework is welded of high-quality swage. The rear wheels are equipped with brake casters that turn freely and easily. The front and rear casters are fixed
to wheel axle with ball bearings.
The working process is as follows: insert the fork under the weights, brake the rear wheels if required, throw handle or step on the foot pedal to press pump
element so that the oil in pump tank enters the bottom of piston cylinder and lift the piston rod assembly upwards a stroke and through chain lift fork upwards
twice stroke. Repeatedly throw handle or step on foot pedal to hoist weights. When the fork is lifted to the highest position, pressure will get back to oil tank via
relief manually to haul loads from place to place. To unload the weights, pull up the lever so that the spill valve will be open and via the spill valve the working
oil in piston cylinder will get back to oil tank under the weight of loads and the fork proper, piston rod assembly and the fork will lower to preset position; then
withdraw the fork and unload the weight. Thus, the dual effects of hoist and hauling are obtained.
Safety guidance
• Operator should read all warning signs and instructions here and on the stacker before using it.
• Do not operate a hand stacker unless you are familiar with it and have been training or authorized to do so.
• Do not operate a hand stacker unless you have checked its condition. Give special attention to the wheels, the handle, the guide frame, the pilot wheel, the
doorframe, etc.
• Do not use on a slopping ground.
• Do not take up any people on the forks.
• The operator had better take on gloves for labor protecting.
• When the goods have been transported or lifted, all people should be away from the forks for 6m.
• Do not load over maximum capacity.
• The weight of goods should be distributed on the two forks, do not use only one fork.
• The center gravity of goods should be that of two forks.
Technical Characteristics
Technical Data
Loading Capacity 1 Ton
Height 3000 mm
Troubleshooting
The forks cannot be up the max height
• The hydraulic oil is not enough -Pour in the oil
The forks cannot be lifted up
• Without hydraulic oil
• The oil has impurities.
• Air come into the hydraulic oil
• Fill in the oil
• Change the oil
• Banish the air
The forks cannot be descended
• The lifting piston (15) or the mast (35) is deformed resulting from overloading
• The fork was kept in a high position for long time with lifting piston bared to arise in rusting and jamming of the piston
• Fork frame and roller sprocket are jammed
• The rollers (42) are not lubricated
• Replace it
• Keeping the fork in the lowest position if not using, and pay more attention to lubricate the rod
• Renovate impurity or replace bearing
• Lubricate them
Leaks
• Sealing parts worn or damaged
• Some part cracked or worn into small
• Replace with a new one
• Replace with a new one