BorMann BSC6000, Руководство оператора

Страница: 13 / 13

www.BormannTools.com
22. POSSIBLE CHARGING PROBLEMS
PROBLEM CAUSE SOLUTION
Bad Battery Error LED may light
when the battery
voltage is less than
2V; or the battery
has a faulty
condition such as
open, shorted cell or
sulfated condition.
Have the battery
tested by a qualified
technician.
Battery not
accepting
a charge
·
Lack of AC input
power
·
Faulty connections
to battery terminals
·
Wrong charge
voltage selection
·
Battery voltage too
low
·
Make sure that the
charger is plugged
into AC outlet and
POWER LED is lit.
·
Unplug the charger
and check the battery
connection; ensure
that there is a good
connection at the
battery terminal/post
and/or vehicle
chassis.
·
Check that the
correct charge
voltage was selected
for the battery being
charged.
·
Ensure enough
charging time was
allowed to charge
battery.
23. MAINTANENCE INSTRUCTIONS
This charger requires minimal maintenance. As with any appliance or tool, a few
common sense rules will prolong the life of the battery charger.
ALWAYS BE SURE THE CHARGER IS UNPLUGGED BEFORE PERFORMING ANY
MAINTENANCE OR CLEANING.
1. Store in a clean, dry place
2. Coil up the cords when not in use.
3. Clean the case and cords with a slightly damp cloth.
4. Clean any corrosion from the clamps with a solution of water and baking soda.
5. Examine the cords periodically for cracking or other damage and have them
replaced if necessary.
6. WARNING: All other service should be done by qualified personnel only.