www.BormannTools.com
1. Open the top door of the welder
2.
.
Lift the Pressure Adjuster
(PIC C-C1)
out of the way and move the Rocker Arm
(PIC. C-C2)
away
from the drive roller.
3.
Remove the Drive Roller Thumb Screw
(PIC. C-C3)
by turning it counter clockwise and pulling it away
from the roller.
4.
Remove the Drive Roller and view the wire sizes stamped on each side of the roller.
5.
Install the Drive Roller in the orientation so that the size of the wire you are using is facing you on the
side of the drive roller.
6.
Reinstall the Drive Roller Thumb Screw
(PIC. C-C3)
.
7.
Put the Rocker Arm
(PIC. C-C2)
back in place and reset the Pressure Adjuster
(PIC. C-C1)
.
INSTALLING THE WIRE
The welder could be used with a max. 1kg wire spool only. To install the wire spool follow the procedure
listed below:
1.
Open the door of the welder and remove the wing nut
(PIC. C-C1)
and spacer from the Wire Spool
Spindle.
2.
Slide the 4 inch Wire Spool onto the Wire Spindle and reinstall the spacer and wing nut.
C1
C2
C3
