BorMann BBC8520, Руководство пользователя, Страница: 3 / 8

EN
WWW.BORMANNTOOLS.COM
3
Operating instructions
Green LED
Red LED
BOOST Button
EC5 Plug
Positive Clamp
Negative Clamp
Smart Cables “BOOST” Mandatory Operations
1) If with correct connection between Jump Starter and vehicle battery (Red
LED keeps on and green LED is off), press and hold BOOST button for 3 sec-
onds (after a buzzer sound, the green LED is on and red LED is off). Usually
this is because the vehicle battery capacity is rather low.
2) Start the engine (refer to section "jump starting").
Cautions:
1) Under normal circumstances, do not use the mandatory operations.
2) The spark proof, reverse polarity protection and short circuit protection
features are disabled after Boost button is pressed. Pay very close attention
to the polarity of the battery before using this mode. Do not allow the pos-
itive and negative battery clamps to touch or connect to each other as the
item will generate sparks and high heat if not used properly.
LED and Buzzer Communication:
No. Red LED Green LED Buzzer Sound Condition
1 On Off One sound Jumper cable and device are connected.
2 Off On One sound Jumper cable and vehicle battery are connected.
Ready to start the engine.
3 Slow flash Off No buzzer Lithium battery voltage in
device is rather low.
4 Slow flash Off No buzzer Have not turned on the ignition switch within the regulated time.
To resolve this, you need remove clamps from vehicle battery, and
connect again when No.1 condition occurs.
5 Fast flash Off Fast buzzer Red and black clamps are connected with each other.
6 Fast flash Off Fast buzzer Reverse connection of clamps.
7 Off Fast flash No buzzer Engine is started.
8 Off Fast flash No buzzer Vehicle’s battery voltage is higher than Jump Starter’s.
Connecting to the battery
1) Identify polarity of battery posts. The positive battery terminal is typically marked by these letters or symbol (POS,P,+). The negative battery terminal is typ-
ically marked by these letters or symbol (NEG,N,-).
2) Do not make any connections to the carburettor, fuel lines, or thin metal parts.
3) Identify if you have a negative or positive grounded vehicle. This can be done by identifying which battery post (NEG or POS) is connected to the chassis.
4) For a negative grounded vehicle (most common): connect the RED POSITIVE jumper clamp first to the positive battery terminal, then connect the BLACK
NEGATIVE jumper clamp to the negative battery terminal or vehicle chassis.
5) For a positive grounded vehicle (very uncommon): connect the BLACK NEGATIVE jumper clamp first to the negative battery terminal, then connect the RED
POSITIVE jumper clamp to the positive battery terminal or vehicle chassis.
6) When disconnecting, disconnect in the reverse sequence, removing the negative first (or positive first for positive ground systems).
Jump starting
1) This unit is only for emergency use, not for frequent commercial use! ENGINE START
socket is ALWAYS activated! Do not attempt to jumpstart your vehicle when the device
battery capacity is below 20% (observe battery status indicator on the unit).
2) Turn off the vehicle ignition and all accessories (radios, lights, air conditioners, etc.),
and disconnect electronic devices.
3) Connect the jumper clamps to the correct polarity battery terminals.
4) Connect the EC5 plug of jumper cables to the ENGINE START socket of device.
5) Try starting the vehicle (turn on the ignition switch). Most vehicles will immediately
start. Stop if the vehicle does not start after 5 seconds of engine cranking. The jump-
start feature is designed for short term operation only, and more than 5 seconds may
cause damage to the unit. Allow the jump starter to cool down for at least 3 minutes
after each jumpstarting.
6) Disconnect the cable from the device immediately after engine starts, and then re-
move from battery terminals.