EN
WWW.BORMANNTOOLS.COM
3
1. Do not attempt to operate the tool until you read and understand all safety precautions and manual instructions.
2. Never allow to use oxygen or combustible gas as a power source for the tool Use filtered, lubricated, regulated compressed
air only.
3. Never use gasoline or other flammable liquids to clean the tool. Vapours in the tool Mill ignite by a spark and cause the tool
to explode.
4. Do not exceed maximum permissible operating pressure 7.8bar (115 psi).
5. Any tool equipped with contact actuation with a safety yoke shall not be used -if changing one driving location to an other
involves the use of stairs, ladders or scaffolding for closing boxes or crates and for fitting transportation safety systems.
6. Disconnect the tool from air supply before clearing jams performing repairs and during non-operation
7. Do not keep the trigger pulled on safety yoke mechanism when carrying or holding the tool.
Never carry the tool by the hose or pull the hose to move the tool. Carry the tool only by the handle.
8. At the workplace, always wear the protective equipment such as safety and head protection.
9. Do not use a check valve or any other fitting that allows air to remain in the tool.
10. Never point any operational fastener driving tool at yourself or at another person.
11. Protect your eyes and ears.
12. Wear safety glasses.
13. Check and replace any damaged or worn components on the tool.
1. Add a few drops of suitable recommended oil into the air inlet.
2. Install a quick-connect fitting to the tool.
3. Connect the tool to an air compressor using a 3/8” I.D hose. Make sure the magazine must be empty of all fasteners and
the hose has a rated working pressure exceeding 200 psi (13.8 bar) and a female quick coupler.
4. Regulate the air pressure to obtain 62 psi(4.1 bar) at the tool. Check the operation of the safety yoke mechanism following
the instructions in this manual.
5. Insert fasteners into your tool following the instructions of loading the tool.
6. Reconnect the hose to the tool.
7. Test for proper fastener penetration by driving fasteners into a piece of wood. If the fasteners do not achieve the
desired penetration, regulate the air pressure to a higher setting until the desired penetration is achieved. Do not exceed 7
bar(100psi) at the tool.
Removing a jammed fastener from the Tool
1. Disconnect tool from compressed air system.
2. Press down on latch and pull back on magazine.
3. Remove the jammed fastener and push magazine cover forward until catches.
Required pressure:
60-100psi(4-7bar)
Nail Capacity:
150pcs
Dimensions:
47x147x205mm
Weight:
0.9kg
Nail length:
6-16mm
Safety Instructions
Tool Operation
Technical Data
