BorMann 037415, Руководство пользователя, Страница: 5 / 15

EN
WWW.BORMANNTOOLS.COM
5
Operating instructions
Helpful Hints for Getting Started
Automatic ON/OFF:
The motor on this pressure washer does not run continuously. It only
runs when the trigger of the spray gun is squeezed. After following the
start up procedures in this manual, turn the pressure washer ON and
squeeze the trigger for activation. See “Operating Instruction” section in
this manual for further details.
Bleeding the Gun:
It is very important to bleed the gun before using the pressure washer.
Squeeze the trigger to allow any air that is trapped inside of the unit and
hose to escape. Continue to squeeze trigger until a steady stream of wa -
ter comes from the nozzle. (This process may take up to 2 minutes). See
“Operating Instructions” section for this process.
WARNING! This unit is to be connected to a cold water source ONLY.
WARNING! The motor of this pressure washer will NOT run. It will only operate when the trigger is squeezed.
- Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
- Connect nozzle and nozzle extension.
- Check gauze filter is clear of any blockage.
- Connect the water supply hose.
- Check that the hose has no kinks in it.
- Turn on water and check for leaks.
- Depress trigger to allow air to be expelled though the pump and hoses, lock trigger.
- Plug in machine and turn on switch.
- Unlock trigger and use the pressure washer.
Shut down
1. Turn off the motor (push switch to the off position).
2. Unplug the unit from the power source.
3. Turn off the water supply.
4. Press the trigger of the gun to depressurize the system.
5. Disconnect the garden hose from the pressure washer.
6. Wipe all surfaces of the unit with a damp clean cloth.
7. Engage the gun safety lock.
CAUTION: ALWAYS turn off the unit’s motor BEFORE turning off the unit’s water supply.
Serious damage could occur to the motor if the unit is run without water.
CAUTION: NEVER disconnect the high-pressure discharge hose from the machine while the system is still pressurized. To depressurize the unit, turn off the
motor, turn off the water supply and squeeze the trigger 2-3 times.
Adjustable spray nozzle
Turn off the spray lance first, hold the rear part of spray nozzle, then
turn the front part of spray nozzle clockwise, Water may be sprayed
out from the spray nozzle in fan shapes (fig 2); Turn the front part
of spray nozzle anti-clockwise, Water may be sprayed out from the
spray nozzle linearly (fig 1).
CAUTION: Water should be sprayed out from the spray nozzle in fan
shapes (fig 2),when cleaning the car or other vehicle.
Fig. 1 Fig. 2
Fig. 3
Fig. 4
Water inlet screen
The water inlet filter must be inspected regularly, so as to avoid blockage and restriction in the water supply to the pump (fig 3).
Hose-reel handle
The hose reel handle turns down for use and up for storage. To turn up the handle, pull out and turn up (fig 4).