BorMann 035541, Руководство пользователя, Страница: 3 / 9

EN
WWW.BORMANNTOOLS.COM
3
WARNING: Please read understand this manual before operating the compressor.
READ THE INSTRUCTION HANDBOOK Before positioning, operating or adjusting the compressor, read the instruction handbook carefully.
RISK OF ELECTRIC SHOCK
Caution: before doing any work on the compressor it must be disconnected from the power supply.
RISK OF HIGH TEMPERATURES
Caution: the compressor contains some parts which might reach high temperatures.
RISK OF ACCIDENTAL START-UP
Attention, the compressor could start automatically after a power-cut if not switched off.
USE WITH TOOLS
WARNING!
Always disconnect the air tool from the air compressor before changing tools, accessories, servicing and during non-operation.
IMPORTANT: When securing wheel nuts it is important to set the regulator to the minimum setting, then use a torque wrench to set fastener torque. Wheel
nuts must be tightened to the vehicle manufacturer’s recommendation.
Safety instructions
SAVE THESE INSTRUCTIONS AND MAKE THEM AVAILABLE TO OTHER USERS OF THIS TOOL!
IMPORTANT INFORMATION
Read and understand all the operating instructions, safety precautions and warnings in the user guide before operating or maintaining this compressor. Most
accidents that result from compressor operation and maintenance are caused by the failure to observe basic safety rules or precautions. An accident can often
be avoided by recognizing a potentially hazardous situation before it occurs, and by observing appropriate safety procedures. Only use the compressor as
recommended by the manufacturer.
SAFETY (IMPORTANT SAFETY INSTRUCTIONS FOR THE USE OF THE COMPRESSOR)
1. NEVER TOUCH MOVING PARTS
2. NEVER OPERATE WITHOUT ALL GUARDS IN PLACE
3. ALWAYS WEAR EYE PROTECTION; compressed air must never be aimed at anyone or any part of the body.
4. PROTECT YOURSELF AGAINST ELECTRIC SHOCK; prevent body contact with grounded surfaces such as pipes, radiators, ranges and refrigeration enclosures.
Never operate the compressor in damp or wet locations.
5. DISCONNECT THE COMPRESSOR from the electric mains before operating, inspecting, servicing and cleaning the unit and before replacing or checking any
parts.
6. RISK OF ACCIDENTAL STARTING; do not move the compressor while it is still plugged into the mains. Make sure that the main switch is turned OFF before
plugging the compressor into the mains.
7. STORE COMPRESSOR PROPERLY when not in use, the compressor should be stored in a dry place.
8. KEEP WORK AREA CLEAN; cluttered areas invite injuries. Clear all work areas of unnecessary tools, debris, furniture etc. Risk of electric shock – do not expose
the compressor to rain and don’t use it in damp or wet locations. Keep work area well lit and well ventilated. Risk of fire or explosion. Do not carry and operate
the compressor or any other electrical device near the spray area. Don’t use the compressor in the presence of flammable liquids or gases. Compressor pro-
duces sparks during operation. Never use compressor in sites containing lacquer, paint, benzene, thinner, gasoline, gaes, adhesive agents and other materials
which are combustible or explosive.
9. KEEP CHILDREN AWAY; do not let other people come into contact with compressor extension cable. All visitors should be kept safely away from work area.
10. DRESS PROPERLY; no not wear loose clothing or jewelry. They can be caught in moving parts. Wear protective hair covering to contain long hair.
11. DO NOT MISHANDLE CABLE; never pull it to disconnect from the plug socket.
Keep cable from heat, oil and sharp edges and avoid crushing it.
12. MAINTAIN COMPRESSOR WITH CARE; inspect cable periodically and if damaged, have it repaired by an authorised service facility Inspect extension cords
periodically and replace if damaged.
13. OUTDOOR USE EXTENSION CABLE; when compressor is used outdoors, use only extension cable intended for use outdoors and so marked.
14. STAY ALERT; watch what you are doing, Use common sense. Do not operate compressor when you are tired It should never be used by you if you are under
the influence of alcohol, drugs or medication that make you drowsy.
15. CHECK DAMAGED PARTS AND AIR LEAKS; before further use of the compressor, a guard or other part which is damaged should be carfully checked to deter-
mine that the compressor will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of
parts, mounting, air leaks and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced
by an authorised service centre unless otherwise indicated elsewhere in the user guide.
Have defective pressure switches replaced by an authorised service centre. DO NOT USE THE COMPRESSOR IF THE PRESSURE SWITCH IS FAULTY.
16. USE THE COMPRESSOR CORRECTLY; OPERATE THE COMPRESSOR
ACCORDING TO THE INSTRUCTIONS PROVIDED HEREIN; never allow the compressor to be operated by children, individuals unfamiliar with its operation or
unauthorised personnel. The compressor has been designed and manufactured exclusively to produce compressed air. EVERY OTHER USE, DIFFERENT AND
NOT FORESEEN BY ALL INDICATED, RELIEVES THE MANUFACTURER OF POSSIBLE CONSEQUENT RISKS. In any event the use of the compressor different to that
agreed in the purchase order RELIEVES THE MANUFACTURER FROM ALL LIABILITIES WITH REGARD TO POSSIBLE MATERIAL DAMAGE AND PERSONAL INJURY.
17. KEEP MOTOR AIR VENT CLEAN.
18. OPERATE COMPRESSOR AT THE RATED VOLTAGE as specified on nameplates (tol/- 5%).
19. NEVER USE A COMPRESSOR WHICH IS DEFECTIVE OR OPERATING ABNORMALLY; if the compressor appears to be operating unusually, making strange noises
or otherwise appears defective, stop using it immediately and arrange for its repair by an authorised service centre.
20. USE ONLY GENUINE REPLACEMENT PARTS; non-original replacement parts may void your warranty and can lead to malfunction and result in injuries. Do
not modify the compressor. Always contact an authorised service centre for any repairs.
21. TURN THE MAIN SWITCH OFF WHEN THE COMPRESSOR IS NOT IN USE; turn the main switch OFF (pos. «0») and unplug the compressor from the mains.
22. DO NOT TOUCH HOT PARTS OF THE COMPRESSOR.