BorMann 035145, Руководство пользователя

Страница: 4 / 10

EN
WWW.BORMANNTOOLS.COM
4
Operating instructions
Before Operation
→ Fitting and removing the battery
Slide the battery into the handle until it engages. To remove the battery, hold down the battery release
button(A) and pull the battery out of the handle.
Checking the battery status
To check the charge level, press the battery charge level
indicator button.
The charge level is represented by three LEDs
When the battery is fully charged all three LEDs light up.
LED battery status indicator Capacity
3x LED > 70%
2x LED < 70%
1x LED
< 50% (Charge battery!)
Starting Operation
→ Inserting the Battery
Use only original lithium ion batteries with the voltage listed on the nameplate of your power tool. Using other batteries can lead to injuries and pose a fire
hazard.
Set the rotational direction switch 7 to the centre position in order to avoid unintentional starting. Insert the charged battery 5 into the corresponding place
of the machine.
Reversing the Rotational Direction
The rotational direction switch 7 is used to reverse the rotational direction of the machine. However, this is not possible with the On/Off switch 8 actuated.
Right Rotation: For drilling and driving in screws, push the rotational direction switch 7 left to the stop.
Setting the Torque / Setting the Operating Mode
→ Gear Selection, Mechanical
Actuate the gear selector 4 only when the machine is at a standstill.
Two speed ranges can be preselected with the gear selector 4.
Low speed range; for screw driving or working with
large drilling diameter.
High speed range; for working with small drilling diameter.
If the gear selector 4 cannot be fully engaged, lightly rotate the drive
spindle with the drill bit by twisting the drill chuck.
Switching On and Off
To start the machine, press the On/Off switch 8 and keep it pressed.
The light 6 is lit when the On/Off switch 8 is slightly or completely pressed in and permits to light the work area when the lighting conditions are bad.
To switch off the machine, release the On/Off switch 8