BorMann 030751, Руководство пользователя

Страница: 6 / 16

EN
WWW.BORMANNTOOLS.COM
6
When you empty water from a water tank
1. Remove water tank from the device.
2. Hold the tank by the handle and carry it gently.
3. Tilt the tank to the direction as shown and slowly empty the water out of the tank.
4. Set the tank in the device.
Note: After the dehumidifying operation, water is collected in the water tank. When the tank
is full of water, the device stops operating automatically and the buzzer sound.
The buzzer sounds for 20 seconds when the tank is taken out during operation.
Your dehumidifier will stop automatically after the hours set by the timer (0H to 24H).
In any mode, you can press ''Timer'' switch to set the timer 0H to 24H.
Plug in the dehumidifier to an outlet.
If the water is full of water indicator light, the rest are not displayed.
Make sure that the water tank is set properly.
Press key. Dehumidification mode bulb will light up.
Set the unit to the desired operation by pressing ''Mode'' switch.
Every time you press the ''mode'' switch, the mode selection bulbs will turn on.
Setting the timer
Pressing ''Timer'' switch to set the timer.
Press timer to program time and ''timer'' light ''Hr'' comes on while timer is programmed.
Before programming, make sure that the timer function has not been activated (the light must be off).
The following timer programs are available.
24 Hour programmable timer can be used to switch on the unit after a desired period of time or can be used to switch off the unit after a desired period of
time. Note: Timer can be selected between 1 to 24 hours (in increments of 1 hour).
With the lapse of time, the timer lamp lighting up will indicate the remaining time.
The unit will stop operating after the lapse of set time.
WARNING: To avoid damages to the power cord, do not pinch the cord in a door.
WARNING: Be sure to prevent children from getting in a closet when using the unit in the closet.
Stop operating
Press key again. The mode select lamp will go off and the unit will stop operating.
Buzzer
Whenever each switch is pressed, the buzzer will sound.
Note: Due to the protective function for the machine, the dehumidifying operation will be started after approx. 3 minutes, when the unit is plugged in or
restarted immediately after stopped.
Efficiency of the dehumidifier is influenced by the air outside the room.
For operating efficiently, try to avoid opening and closing the windows and the doors.
For proper performance, operate the dehumidifier under the usable operating temperature. For safery purposes, the dehumidifying operation will be
stopped automatically and changed to the air fan operation when the ambient temperature is higher than 36⁰C.
Circulation of the refrigerant may cause sound within the dehumidifier when the operation is started. After the circulation is stable, the sound will be lowed.
To change the timer set
Press timer switch to set the desired time.
To cancel the time operation press timer switch the timer lamp will go off.
To stop the timer operation press switch again.
Operating instructions
Handle