BorMann 022343, Руководство пользователя, Страница: 6 / 13

EN
WWW.BORMANNTOOLS.COM
6
4. Attach the rubber legs to the cooker by turning the cooker upside down
and screwing them into the openings on the cooker bottom.(Fig. 12)
5. Install the burners.
6. Place the trivets on top of the burner. The trivets can be adjusted by
turning the screws and then the pan can be put on the trivets steadily.
7 .Push the rubber hose onto the hose joint as far as it will go. Do not use
a vinyl plastic hose, as this can be dangerous. Secure the hose with both
sides of hose clamp.(Fig.13) see to it that the rubber hose does not touch
a part of the gas cooker nor lies underneath it.
8.When choosing a place to put the gas cooker,be sure to pick a spot
that is firm and level. The gas cooker need plenty of space and air.
Allow at least 15cm of space on the sides and 100cm above the unit.
(Fig.14) if the space is less than 15cm from the in-flammable walls, be
sure to provide a heat insulation board. Also be sure to keep paper, oil,
and all other inflammable objects away from the gas cooker.
How to use the device
1. To light the burners:
a. Open the main gas valve. Push the gas control knob in and turn it towards the MAX position (counter-clockwise) until you
hear the click. Make sure that the burner has been lit (Fig.15) in this position, double burner will light up both the small and
large burners. To use only the small burner, release the gas control knob and turn it further to the MIN position. (Fig. 16)
b. To adjust the flame size.
Set the gas control knob to a suitable position between MAX (full flame size) and MIN position (small flame size)
Fig 12.
Fig 13.
Fig 14.
Fig 15.
Fig 16.
Fig 16.
Fig 17.
Fig 18.