BorMann 020745, Руководство пользователя

Страница: 5 / 9

EN
WWW.BORMANNTOOLS.COM 5
Operating instructions
Service and maintenance
Before any work on the machine itself, disconnect the mains plug from the socket.
Blowing (see figure A)
- For operation mode ''blowing'', firmly attach the nozzle 7 in alignment with the arrow mark onto the air outlet 5.
Vaccuming (see figure B)
- For operation mode vaccuming, firmly attach the nozzle 7 in alignment with the arrow mark onto the air intake 9.
- Additionally, always mount the dust bag 8 onto the air outlet 5.
Starting Operation
- Observe the mains voltage! The voltage of the power source must correspond with the data on the plate of the machine.
Switching On and Off
To start the machine, press the On/off switch 2.
To lock the On/off switch, keep it pressed and additionally push the lock-on button 3.
To switch off the machine release the On/off switch 2. When the On/Off switch 2 is locked, press it first and then release it.
Regulating the Air flow
Adjust the required air volume by turning the thumb-wheel 4:
Turning in clockwise increases the air volume.
Turning in Reduces the air volume.
Working Advice
During -blowing- operation, take care that no debris/impurities can be drawn into the air intake 9.
Never vacuum without a dust bag.
DO not vacuum sharp-edged or hot materials such as glass splinters, hot ash or metal chips.
When vaccuming, empty the dust bag regularly.
Observe the environmental regulations when disposing waste.
- Before any work on the machine itself disconnect the mains plug from the socket.
- For safe proper working, always keep the machine and ventilation clean.
If the machine should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an after-sales service center.
If the replacement of the supply cord is necessary. this has to be done by an authorized service agent in order to avoid a safety hazard.
Carbon Brushes (see figure C)
Check the length of the carbon brushes approx. every 2-3 months and replace the carbon brushes if required.
Never replace only a single carbon brush!
Criteria for replacement of the carbon brushes: A dotted or broken line is visible on one of the large side surfaces of each carbon brush. When either of both
carbon brushes is used up to this line, then both carbon brushes should be replaced immediately in order to protect the armature against possible damage.
Note: Use only carbon brushes supplied by Bormann and intended specifically for your product.
- Unscrew the caps 6 using a suitable Screwdriver.
- Replace the spring-loaded carbon brushes and screw the Caps back on again.