19
www.BormannTools.com
PROPER USE OF THE PRESSURE
CLEANER
THIS UNIT IS INTENDED FOR USE WITH COLD WATER ONLY!
DO NOT USE HOT WATER IN THIS PRESSURE CLEANER.
1. Operate the pressure cleaner at no more than the fluid pressure rated for the pressure
cleaner. Never run the pressure cleaner without a water supply. Running the unit without a
water supply will cause irreparable damage to the unit.
2.
Make sure that the water supply you use for the pressure cleaner is not dirty, sandy, and
does not hold any corrosive chemical products. Using a dirty water supply will
compromise the long life of the pressure cleaner.
3. CAUTION - The pressure cleaner can be used for a variety of applications including
washing cars, boats, patios, decks, gara
ges etc. where high pressure is necessary to
remove dirt and debris.
High-pressure water flow can damage the work surface if not used properly!
See
the section titled “Operating Instructions” for more details. Always test the spray in an
open area first.
4.
NEVER move the unit by pulling on the high pressure hose. Use the handle provided on
the top of the unit.
5. Always hold the high pressure gun and wand with two hands. Keep one hand on the
gun/trigger, while supporting the wand with the other hand (se
e diagram).
6.
When dispensing detergent, the pressure cleaner applies detergent to the cleaning area
at low pressure only. Once the detergent has been applied, spray the detergent off of the
work area by using the adjustable nozzle.
ASSEMBLY INSTRUCTIONS
Unpacking The Carton
After opening the carton, please remove all parts and check them against the following list of
components that are included:
A.
Quick Connector
B. Water inlet filter
C. Gun holder
D. Gun saddle
E. Cable Hook
F. Hose Reel W/ Hose
G. High Pressure Hose
H. High Pressure Hose Clip
J. Gun
K. Adjustable Nozzle
L. Cleaning pin
Due to transportation and packaging, some of
the accessories may be supplied
disassembled. Please follow the assembly
instructions.
The machine is always with handle to transport.
