BorMann 011286, Руководство пользователя

Страница: 18 / 25

18
www.BormannTools.com
Connecting the Funnel, Hose and C abinet
1.Place the Bottom Plate (9) which has foam on
each side together with Screen Frame (10) on top of
the Funnel and secure the assembly to the bottom
of the Cabinet with the Bolts (44) Flat Washers and
Nuts.
2 .Connect the Sand Pickup Tube (8) to the front
funnel plate and secure with Bolts
(47) Flat Washers and Nuts. Place Steel Screen (11)
inside the cabinet.
3.Attach the Air Hose Inlet Fitting (45) to the lower
right side of the cabinet.
-- >Connect one side of the Air Hose (52) to the
blasting gun and the other side to the inlet fitting
(45). Secure both sides with air hose clamps (54).
-- >Connect one side of the Vacuum
Suction Hose
(46) to the blasting gun, connect the other end
to the Sand Pickup Pipe (8). Secure both sides
with Vacuum Hose Clamps (53).
Lower shelf and window
1. Install the Lower Shelf (2) with the Bolts (47), Flat Washers and Nuts.
2. Layer the Window Protective Film (25), Glass (27), Acrylic Glass (26)
and Frame (28) over the opening on the Cabinet Top Plate and secure in
place with the Bolts
(49) and Nuts.
Note: This air tool may be shipped with a protective plug covering the
air inlet. Remove this plug before set up.
Air supply
TO PREVENT SERIOUS INJURY FROM EXPLOSION:
Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible
gases, or any other bottled gas as a power source for this tool.
1. Incorporate a filter, regulator with pressure gauge, dryer, in - line shutoff valve, and quick coupler for best service,
as shown on Figure L and Figure M. An in - line shutoff ball valve is an important safety device because it controls the
air supply even if the air hose is ruptured. The shutoff valve should be a ball valve because it can be closed quickly.
1
Figure I: Connection Components
Figure J: Lower Shelf and Window