Borger Classic FL 1036, Руководство по эксплуатации

Страница: 126 / 204

— Secure the Börger machine against unauthorized or uncon-
trolled reactivation as described in
Ä
Chapter 2.7 “Securing the
machine against restart” on page 24
— To the extent necessary, amply secure the surrounding area
when performing maintenance. Cordon off the working area
with a red and white safety chain and a warning sign.
— Relieve the pressure in the Börger machine according to
Ä Chapter 6.1.2 “Pressure relief” on page 109 .
WARNING!
Severe injury due to residual pressure!
Despite having depressurized the Börger machine, it may
be under residual pressure in the event of congestion or
lump formation in the medium.
— Take extra care when removing the flange connections
and maintenance openings to prevent accidents caused
by the release of residual pressure.
1. Opening the quick-release cover:
Use a suitable cover to prevent the medium from spouting
out.
2. Place a drip pan underneath.
3. Loosen the four ring nuts (1) uniformly by approx. 5 mm (.
20'') using a wrench.
4. Initially, only open the cover (2) at the bottom (6, on standing
versions) by a small gap (approx. 5 mm (.20'')) to allow all
residual pressure to escape and catch any medium that
spouts out.
5. Completely loosen and remove the four ring nuts (1).
6. Remove the quick-release cover (2).
7. Remove the cover-side casing protection plate (3).
8. Clean the interior of the Börger machine as described in
Ä
Chapter 6.1.3 “Cleaning the inside” on page 111 .
9. Check the O-ring (4). Replace the O-ring (4) if it shows signs
of damage.
10. Clean the O-ring groove before inserting/reinserting the O-
ring (4).
11. Press the O-ring seal (4) carefully into the O-ring groove.
Maintenance and Repairs
BA-Classic FL_en-US, 03.05.2018 www.boerger.de / www.boerger.com 126