Version 1.1
3 INSTALLATION GUIDE
Before start, perform the steps described below. Check figure 7.1 for the position of connectors and figure
5.1 for the position of jumpers.
1. Attach RakunLS1 and (optionally) PHYBoard add-on as shown in figure below:
Illustration 3.1: Installation
2. Check presence of the following jumpers:
Jumper
Setting
Function
P13
1 – 2
USB is connected to USB connectors
P12
1 – 2
USB is connected to USB connectors
P11
1 – 2
USB is connected to USB3.0 connector
P8
1 – 2
USB is connected to USB3.0 connector
P15
1 – 2
SD Boot
P16
2 – 3
Console is UART2
P17
2 – 3
Console is UART2
Table 3.1: Default jumper positions
3. Install uSD card with boot image to uSD slot.
4. Attach PC to Console connector with USB cable. Start terminal application on PC. Set it to 115200 kb/s, 8
bit, no parity, one stop bit (115200 8N1).
5. Optionally attach Ethernet, HDMI, USB.
PastLS1 Qseven carrier board for Rakun LS1
