bora Pro PKG3, Инструкции по эксплуатации и монтажу

Страница: 21 / 44

EN
21
Installation
www.bora.com
Levelling the cooktop (if necessary)
1
2
Fig. 5.20 Cooktop and height adjustment plates
[1]
Cooktop
[2]
Height adjustment plates
X
X
If applicable, insert the height adjustment plates [1].
Securing the cooktop
1
3
2
Fig. 5.21
Mounting brackets
[1] Mounting bracket
[2] Washer
[3] Screw
X
X
Secure the appliance using the mounting brackets [1].
X
X
Tighten the mounting brackets with the screw [3] using the
washer [2] with max. 2 Nm.
X
X
Verify that the alignment is correct.
5.7.2 Installation rotated by 180°
(alternative installation variation)
Installation rotated by 180°
X
X
Rotate the cooktop 180°.
X
X
Turn the gas connection hose so the connection is at the rear.
X
X
For the installation, proceed as described above.
X
X
Change the installation direction in the configuration menu
(see “Configuration menu”).
i
If installation is rotated by 180°, the ports for the control
knobs and the automatic extractor function are at the
rear.
i
Cables of sufficient length are provided.
X
X
Tighten the universal nut [2].
X O
The wave spring (if used) must be pressed flat.
X
X
Remove the sticker [3].
X
X
Place the knob ring [4] on the knob housing [1].
5.7 Installing the cooktops
i
Clearance of one millimetre should be planned between
the built-in appliances.
i
A clearance of two millimetres should be planned around
the built-in appliances.
i
It is recommended to install a mounting rail between
adjacent cooktops (mounting rail PZMS available as an
accessory).
i
The cooktop can also be installed rotated by 180°.
5.7.1 Installing the cooktop
Inserting the cooktop (ports on the front)
3 2 1
Fig. 5.19
Inserting the cooktop
[1] Control knob and automatic extractor function ports (front)
[2] Cooktop
[3] Worktop cut-out
X
X
Insert the cooktop [2] into the worktop cut-out [3].
X
X
Align the cooktop [2] exactly.
X
X
For a normal installation, please note that the ports for the
control knobs and the automatic extractor function [1] are at
the front.
i
The connection cables should be guided to the rear. Use
the cable holders provided.