Tracer
Page 6 of 13
Boost Technology
The Visor
Refer to the picture above while following the instructions below.
The Brim of the Visor contains a gyroscope, a device that senses the motion of your head and converts that to motion of the cursor on
the screen. To properly sense the motion of your head, the visor must be worn with the brim at the front, and the gyroscope in front of
your forehead.
The Data Cable
has a modular plug at one end that is connected to the transmitter during use.
The Adjustible Strap can be used to snug the visor onto your head. The cutout in the strap should be centered around the small bump
at the base of the user's skull. Slide the arms of the strap up the sides of the headband until the visor fits comfortably.
For Hands-Free Mousing
Important - Make sure the battery has been charged for at least 14 hours before initial use.
1.
Plug the data cable from the visor into the center jack on the transmitter connector.
2.
Start the computer with the receiver properly connected and the transmitter in the receiver cradle.
3.
Remove the transmitter from the receiver cradle and place it out of the way. It may be left on the desktop or any
other surface, or it may be secured in the supplied In Use Cradle. (See section below on the installation and use of
the in use cradle.) The LED on the receiver cradle will blink rapidly once communication begins.
4.
When first turned on, and each time the visor is disconnected from or connected to the transmitter, the cursor may
drift across the screen in one direction to a side or corner. This is normal. If this occurs, lay the visor right side up on
a stable surface. The system should stabilize within five seconds.
5.
Wear the visor on the head like an athletic cap. Adjust the strap as necessary to keep visor comfortable and stable.
6.
Control the cursor on the screen by turning your head in a natural motion .
