E
E
N
N
G
G
L
L
I
I
S
S
H
H
SECURITY TIPS:
SECURITY TIPS:
Read all safety instructions before operating XPA amplifier.
Install equipment as follow condition.
-
Install in a flat place, not bending or curved.
-
Do not install near water and moisture.
-
Place power amplifier away from heat source, such as radiators or other heat source.
Keep in mind the following when connecting amplifiers
-
Read the owner manual before connecting the amplifier
-
Connect each connection of the amplifier perfectly. If not, it maybe cause hum, damage,
electric shock in case of misconnection.
-
To prevent electric shocks, do not open top cover.
-
Connect the power cord with safety after check of AC power.
Only a qualified person can repair this power amplifier .
D
D
E
E
S
S
C
C
R
R
I
I
P
P
T
T
I
I
O
O
N
N
:
:
1 – Power switch
Use this switch to switch your power amplifier on.
2 – Power indicator
This indicator lights when the power amplifier is switching on
3 – CLIP indicator
If the vumeter stay in right part, you are in a state of overmodulation ( distortion at extremely high
volumes ). In this case, check the output signal of your mixer and turn down the input gain control
Please keep in mind that the power amplifier cannot correct any distortion.
4 – Channel vumeter
This vumeter indicates the level of the signal of the outputs A & B
5 – Protection indicator
When this indicator lights, that means the power amplifier is in the protection mode. Switch off the
device
and find out the problem.
This power amplifier is protected against over heat, over load, short circuit, DC, softstart
