Booma-RC Hidden Ignition Switch, Руководство пользователя

Страница: 5 / 16

5
PLEASE NOTE: One of the safety features is that The Hidden Igni-
tion Switch draws it’s power from your models’ receiver so The
Hidden Ignition Switch is completely inoperable unless connect -
ed to your model’s receiver and the receiver is powered up!
The Hidden Ignition Switch also requires one receiver channel to
operate and is set to switch at approximately 50% of stick posi -
tion. It is recommended to connect The Hidden Ignition Switch
to a switch channel on your receiver and adjust the switch until
The Hidden Ignition Switch operates as required. Setting up a
transmitter for switching will differ for each transmitter type so
please refer to your transmitter manual for switch channel set -
ting.
FOR THE TECHNICALLY MINDED ONLY
The Hidden Ignition Switch has a dead-band where neither an
On or Off state is active. This functionality is built into The Hid -
den Ignition Switch so that Switch flutter cannot happen.
Also a bad signal (no pulse or less than 50% mark space ratio)
must be present for more than 20 continuous frames before The
Hidden Ignition Switch will kill the ignition. In most modern re -
ceivers fail safe is built in so this condition should never be met
except as a complete system safety feature.
This dead band feature comes at a cost of a small delay (approxi-
mately 500 - 600 milliseconds) in switching ON/OFF.
PLEASE NOTE
Please observe correct connection polarity i.e. RED is battery
positive and BLACK is battery negative .
An Incorrect polarity connecting will not allow your battery to
supply power to the Ignition.