Attach the remote
The following attachment methods allow you to install the Mirco Remote on a variety of handlebar
configurations. The strap will wrap securely around diameters as small as 22.2 mm up to the hoods on a
road brake/shift lever.
• 22.2 mm diameter near the
grips.
• Below the brake/shift lever hood
on a road bike.
• 31.8 mm at the centre of a road
bar.
• Optional: Use the bar-end plug adaptor for the end of the handlebar
installation. Sold separately. PN W588932.
• Aero section of a road bar.
European Union Compliance
Transmission Frequency: 2.4GHz
Bluetooth: 2402MHz ~ 2480MHz
ANT+: 2457MHz
Bluetooth Max Power: <6dBm
ANT+ Max Power: <6dBm
Operating power: 3 V D C
Operating temperature: 0ºC ~50ºC
RF exposure compliance distance is 20 millimetres.
Trek Bicycle Corporation and Bontrager hereby
declare that the wireless devices identified as
Transmitr MicroRemote is in compliance with the
following European Directives:
• R&TTE Directive 1999/05/EC - RED 2014/53/EU
• EMC Directive 2004/104/EC -
EMCD 2014/30/EU
• LVD Directive 2006/95/EC - LVD 2014/35/EU
• RoHS Directive 2011/65/EU The full text of the
EU declaration of conformity is available from your
dealer, or at the following internet address:
http://www.bontrager.com/support
• RoHS Directive 2015/863/EU
Korean Compliance
인증자 상호: 트렉바이시클 코리아 기기의 명칭:
특정소출력무선기기 (무선데이터통신시스템용
무선기기 모델명: TRANSMITR MICROREMOTE
인증자 식별부호: MSIP-CRM-D99-TRANSMITR
MICROREMOTE 당해 무선기기는 전파혼신 가능성이
있으므로 인명안전과 관련된 서비스는 할 수
없습니다. 추가적인 정보나 한글 설명서는 웹사이트
www.bontrager.com 에서 확인하실 수 있습니다.
Keep batteries away from children.
If the battery closure does not function, do not
use the product.
If a battery is swallowed or inserted into the
body, seek medical help immediately.
WARNING
Warranty
The Bontrager Transmitr MicroRemote is covered
by a warranty. For details, visit www.trekbikes.com
Trek Bicycle Corporation
contact information:
North America
Trek Bicycle Corporation
801 West Madison Street
Waterloo, WI 53594 USA
Tel: 800-313-8735
Europe
Bikeurope BV
Ceintuurbaan 2-20C
3847 LG Harderwijk
The Netherlands
Tel: +31 (0)88 4500699
Australia
Trek Bicycle Corp. Au.
8 Townsville Street
(Level One)
Fyshwick (ACT)
2609 AU
Tel: +61 (02) 61 732 400
Remote battery
The battery is not rechargeable. It uses a coin-type CR1632 battery.
Battery installation
1. Twist the button assembly
anticlockwise to remove it from
the housing and strap
assembly.
4. Slide the new battery into the
battery carrier. Be sure to have
the plus (+) side facing you.
2. Push the button assembly out
of the top cover.
5. Press the battery and button
assembly back into the top
housing cover.
3. Slide the old battery out and
dispose of properly.
6. Twist the button assembly
clockwise a quarter-turn
onto the housing and strap
assembly.
The small tabs should align
when correctly assembled.
Statements of Regulatory
Compliance
FCC Compliance
Transmitr MicroRemote -
FCC ID: 2AHXD-563210
These devices comply with part 15 of the
FCC Rules.
Operation is subject to the following conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
NOTE:
This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or experienced radio/
TV technician for help.
NOTE: TREK BICYCLE CORPORATION
IS NOT RESPONSIBLE FOR ANY RADIO
OR TV INTERFERENCE CAUSED BY
UNAUTHORISED MODIFICATIONS TO
THIS EQUIPMENT. ANY CHANGES OR
MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE MANUFACTURER OF
THIS DEVICE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE DEVICE.
Industry Canada Compliance
Bontrager Transmitr MicroRemote -
(P/N 563210),
CAN ICES-3(B)/NMB-3(B) IC: 21334-563210
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may
not cause interference, and (2) this device must
accept any interference, including interference that
may cause undesired operation of the device.
Le present appareil est conforme aux CNR
d’Industrie Canada applicable aux appareils radio.
Exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes: (1) l’appareil ne
doit pas produire de brouillage, et (2) l’utilsateur
de l’appareil doit accepter tout brouillage
radioélectrque subi, meme si le brouillage est
susceptible d’en compromettre le fonctionnement.
This Bontrager equipment complies with FCC
and IC radiation exposure limits set forth for an
uncontrolled environment. The radiated output
power of the Transmitr Wireless Device is below
the Industry Canada (IC) radio frequency exposure
limits. This equipment is in direct contact with
the body of the user under normal operating
conditions. This transmitter must not be co-located
or operating in conjunction with any other antenna
or transmitter.
Status of the listing in the Industry Canada’s
REL (Radio Equipment List) can be found at the
following web address: http://www.ic.gc.ca/app/
sitt/reltel/srch/ nwRdSrch.do?lang=eng
Additional Canadian information on RF exposure
also can be found at the following web address:
http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/
sf08792.html
Cet appareil est conforme aux limites d’exposition
à la fréquence radio (FR) d’IC et de FCC. La
puissance de sortie émise par l’appareil de sans
fil Transmitr est inférieure à la limite d’exposition
aux fréquences radio d’Industry Canada (IC). Cet
appareil est en contact direct avec l’utilisateur
dans des conditions normales d’utilisation.
L’émetteur ne doit pas être co-implémenté ou
utilisé conjointement avec une autre antenne ou un
autre émetteur.
Ce périphérique est homologué pour l’utilisation
au Canada. Pour consulter l’entrée correspondant
à l’appareil dans la liste d’équipement radio (REL
- Radio Equipment List)d’Industry Canada rendez-
vous sur: http://www.ic.gc.ca/app/sitt/reltel/srch/
nwRdSrch. do?lang=fra
Pour des informations supplémentaires concernant
l’exposition aux RF au Canada rendezvous sur:
http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/
sf08792.html
BT19_TRANSMITR MICROREMOTE
