3
Placing the shredder
1.
Place the device on a smooth flat surface.
2. Ensure the device is positioned at a distance from heaters and other sources of heat.
3. Where possible, avoid using extension cables or multi-way sockets. It is advisable to connect the device
directly to the wall socket using the power cable (in accordance with the technical specifications).
4. Plug the power cable into a standard 120-volt AC outlet.
Operating the shredder
A main switch is located on the back of the machine, while a slide switch is on the top of the device and can be
set in three (3) positions.
1.
AUTO
:
when the device is connected to power, and the main switch on the back of the machine is on, the
power light will be blue. The cutting process is automatically initiated as soon as paper or credit card is
inserted into the corresponding feed slot. Please do not insert any credit cards into the feed slot while
shredding paper since the device is incapable of shredding of paper at the same time as credit cards. Once
the chosen material has fully passed through the cutting unit, the cutting process will stop automatically.
2.
REV
is used to fix paper blockages. This changes the cutting direction before an operating cycle has ended
enabling the blades to be released. If you realise that you have unintentionally inserted too much paper, and
the shredding process becomes noticeably slower, set the switch to this position to remove excess paper.
3.
FWD:
The cutting mechanism runs forwards for a few seconds and shreds the material fed in.
The device is only intended for indoor use and for an intermittent operation period of a maximum
of 20 minutes. Do not use the shredder for commercial purposes or outdoors.
Shredder capacity
The C222-A is capable of shredding up to 20 sheets of paper (DIN A4, 75g/m²) into cross cut at once. Paper width
may not exceed 220mm. When shredding small pieces of paper, such as envelopes or credit card receipts, the
paper should be inserted in the middle of the slot. Please ensure that you never insert more than the stated
maximum quantity into the cutting unit as this may damage the device.
The C222-B is capable of shredding up to 16 sheets of paper (DIN A4, 75g/m²) into
micro cut at once. Paper
width may not exceed 220mm. When shredding small pieces of paper, such as envelopes or credit card receipts,
the paper should be inserted in the middle of the slot. Please ensure that you never insert more than the stated
maximum quantity into the cutting unit as this may damage the device.
Start operating
After connecting power, turn on the main switch, touch the switch on the top housing to
“AUTO”
, the device will
then be ready to use.
Shredding paper
Insert several sheets of paper (75g/m²) in portrait orientation into the feed slot. The paper will be detected by the
sensors, the cutting unit will start and the paper will be automatically drawn in. The operation will finish once there
is no more paper in the cutting unit.
