Bonsaii C204-C, Инструкция по эксплуатации

Страница: 4 / 8

3
Overloading:
Overhea
If you insert too much paper top. In this event, set the switch to
“REV” in order to remove the paper. Reduce the number of sheets and then try again.
The motor may overheat if you exceed the maximum period of con a
stated. The shredder will stop automa ally and the indicator light “Overheat” is on.
The device changes into Standby-Mode to cool down and can be used again a er the
indicator is off.
Removal of le over paper:
Turning off:
Set the switch to “OFF” and unplug the power socket. Remove the shredding a achment
and then you will able to take out any scraps of paper that have become caught in the
e very sharp so you should proceed with extra c
the shredder a achment back on top, plug in the power socket and turn the device on
again. You will then be able to start using the device again.
Set the switch to “OFF” in order to turn the device off en ely.
Both abnormal opera y r a oma or overheat/
overload prot ermi nates the power to the unit. If this occurs, you should:
1.Unplug the power cord from the AC outlet to allow shredder to cool down. Tear or cut
off any excess paper from the top of the shredder .
2.Plug the power cord back into the AC outlet and place the Switch in REV. Pull the
r ers ・ Place the Switch back to the Aut
necessary clear the feed opening of any remaining shredded pieces of paper, Keep
fingers away from feed opening to avoid harm
.
3.With the Main Switch in the AUT eed opening clear, you are now
ready to resume normal shredding .
C204-C will shred six (6) sheets of A4 size 75g/m² paper, and will accept paper width up
to 220mm. When shredding small material like envelopes or receipts, insert them
through the middle of the feed opening.
Shredder c apacity:
3.OFF:
“OFF” is used to terminate the power to the shredder. The mode is recommended when
emptying the wastebasket or when the shredder is not in use for a proIonged period of