Bonsaii C149-C, Инструкция по эксплуатации

Страница: 5 / 12

Opera�ng the shredder:
Installa�on
Please check the voltage of your shredders carefully before using. Plug in and press the Main Switch
at the back side of machine head.
On the top of the shredder, there are three (3) se�ngs- AUTO, BLANK and REV.
1. When AUTO is selected, the shredding process is started automa�cally by inser�ng the paper into
the feed opening. The shredder will stop automa�cally when the paper has completed its travel
through the feed opening.
2. REV is used to assist in the removal of a paper jam, which reverses the shredder process prior to a
completed cycle, thus clearing the cu�ers. If you want to stop shredding the paper, please set it to
reverse. The machine will reverse automa�cally and turn back the papers.
3. BLANK is used to terminate the power to the shredder. This mode is recommended when emptying
the wastebasket or when the shredder is not in use for a prolonged period of �me.
Shredder capacity
C149-C will shred eighteen (18) sheets of A4 size 75g/m' paper at once and will accept paper widths
up to 8.7 inches. When shredding small material like envelopes or receipts, insert them through the
middle of the feed opening
Overheat Protec�on
Unpack and set machine upright.
Put the machine on a horizontal surface.
Plug in the machine
The socket-outlet should be installed near the equipment and shall be easily accessible.
Overload Protec�on
C149-C is equipped with an overload protec�on technology. The maximum shredding capacity of this
machine at one �me is eighteen (18) sheets of A4 size 75g/m2 paper. Exceeding the shredding capacity
e.g. inser�ng more than eighteen (18) sheets at one pass, or if the paper is not fed squarely into the
feed opening, the 'Overload' LED indicator lights up and machine starts to reverse automa�cally. Pull
the remaining paper out of the cu�ers, reduce the number of sheets and place the paper back into the
feed a lot.
C149-C is equipped with a motor overheat protec�on technology. When the 'Overheat' LED indicator
lights up, Please wait and allow the unit to cool down before restar�ng. A�er machine cooling down
completely, the shredder is ready to re-start to work.
3