5
Shredding paper
Place the paper in portrait orientation into the corresponding in feed unit. The paper will be
recognized by the sensors, and the cutter will begin to feed the paper through automatically. The
equipment will stop once again after a short period when no paper has passed through the cutter.
When no sheets of paper have been fed through for a period of three minutes, the equipment will
revert to standby mode and have minimal power consumption.
Please press the
button to switch from standby to operational mode.
Please be aware of the maximum number of sheets of paper. Further information can be found on
the device, or in the table below entitled "Product Specification".
Overloading:
If you overload more paper in one go than the machine is able to handle, the overloading display
will turn to red,
and the cutter will stop immediately. Should this happen, then please
reduce the number of sheets and try again. Should this particular fault not be rectified
automatically, then press the up arrow
in order to remove any paper. The machine will then be
reset to either normal or standby mode.
Shredding CDs/DVDs/credit cards
Insert CDs/DVDs/credit cards one by one into the designated in feed slot. Do not hold onto the
holes in the middle of the CD/DVD, as this could result in injury!
Manual in feed:
If a sheet of paper is too thin or too transparent for it to be recognized by the sensors, then please
press the "forward" button
. You can also use the forward and backward buttons to allow any
excess sheets of paper to be shred.
Overheating:
It is possible that the engine may overheat if you exceed the maximum amount of time specified
for continuous operation. This is when the cutter will stop and the overheating light
will turn
red. The machine will then start to cool down while in standby mode, and can be used again when
the light stops flashing.
Removing excess paper:
Switch off the equipment, and disconnect the power supply. Remove the paper tray. Remove any
snippets of paper which have become stuck to the cutter. The blades are very sharp, so please do
take extra care!
Put the paper tray back into position, connect the power cable, and switch on the power. You can
now use the machine once again.
Disconnecting:
Turn off the rear main switch for the equipment to become fully disconnected.
