bonitron M3528M2, Руководство для пользователей

Страница: 11 / 24

User’s Manual
11
3. I
NSTALLATION
I
NSTRUCTIONS
WARNING!
Installation and/or removal of this product should only be performed by a
qualified electrician in accordance with National Electrical Code or local
codes and regulations.
Proper installation of the Model M3528M2 Voltage Monitor Module should be
accomplished following the steps outlined below. Please direct all installation and start
up inquiries regarding this product to your supplier or system integrator.
3.1.
E
NVIRONMENT
The installation site should be dry and clean without extreme temperatures.
3.2.
U
NPACKING
Upon receipt of this product, please verify that the product received matches the
product that was ordered and that there is no obvious physical damage to the unit. If
the wrong product was received or the product is damaged in any way, please
contact the supplier from which the product was purchased.
3.3.
M
OUNTING
The unit is mounted with a standard DIN rail clip attached to the back of the
enclosure. Refer to Figure 6-1 to determine the correct mounting dimensions for
your unit.
3.4.
W
IRING AND
C
USTOMER
C
ONNECTIONS
This section provides information about the field connection of the DC bus and signal
inputs to the M3528M2 Voltage Monitor Module.
Be sure to review all pertinent system documentation as well as the power wiring
information in Section 3.4.1 before proceeding.
For the maximum wire size accepted by the individual field connection terminals,
refer to Table 3-1. Wire types and sizes should be chosen in accordance with
national and local electrical codes to meet the voltage and current levels present for
your application.
Figure 3-1 shows a typical interconnection of the M3528M2 with a DC voltage source
and I/O signals.