ASSEMBLY INSTRUCTIONS
Tools Needed:
Jig Saw or Hole Saw
IMPORTANT:
ALWAYS WEAR SAFETY GLASSES WHEN
DRILLING OR CUTTING
Making the hole
Decide where you would like to install the Bonito
Power Grommet on your desk, furniture, table or
other surface.
Use the hole-cutting template on the back of this
page or your preferred method to mark cutting
guidelines.
Using a hole saw or jig saw, create a 4.21” (107mm)
diameter hole.
1
2
3
installing the bonito Power Grommet in
the hole
1
2
Attach the two
metal clips onto the both
sides of the unit by inserting
the clips into the slots as
shown.
Note: the clips are also available
in the provided hardware kit.
Bend the clips on both sides
before the installation.
ire un
