6.2. TRANSPORT POSITION AFTER COUPLING TO THE FARM TRACTOR
During the transport the
Snow Blade
is in lifted position. To lift the Snow Blade
proceed as follows.
6.2.1 Transport phase after coupling to the farm tractor
a) Start the engine
b) Lift the
Snow Blade
by operating the special hydraulic control
lever of the hoisting devices.
N.B. Make sure that no one is walking within the
reach of the
Snow Blade
6.3. WORK POSITION
The
Snow Blade
is in working position when it is connected to the farm tractor,
ready for use. To put the equipment in working position it is necessary to position
the blade in the direction to which the snow nust be pushed.
6.3.1. Working phase
a) By operating the hydraulic control levers of the farm tractor jacks, position the
blade in the direction to which the snow must be pushed.
b) Drop the blade to the ground by operating the hydraulic control
levers of the farm tractor.
After having carefully performed these operations, the
Snow Blade
is ready for
use.
N.B. Once the lever has been lowered to the ground, do not try to position the
blade during work. In case a different position of the blade is required, carry out
the operations as per points a) and b).
N.B. In case the above procedures are not correctly performed, the Company
Bonatti declines any civil and penal responsibility that may arise from a wrong use
of the Snow Blade.
-11-
