3 Safety instructions
bon SL-85
3 Safety instructions
Please follow the legal requirements on accident prevention and observe the following safety
instructions!
Setting-up and assembly:
GA bon SL-85 Rev 1.0 E 211005.doc
6/20
The split lamp should not be assembled and operated in damp rooms.
Ensure that the device is on a level and stable surface during assembly.
The mains voltage must be the same as stated on the product label.
Operating:
Do not subject the slit lamp to extremes of temperature. It is recommended that the
product be used at temperatures of b10° C and +40°C.
The ophthalmometer must not be used in areas where there is a danger of explosion.
Avoid dropping or splashing water on the device.
The slit lamp must only be used by authorised persons.
Do not attempt to move or shake the slit lamp with excessive force. First check
whether the adjustment screws have been loosened.
The moveable arm and slit projector can move up and down between their bases.
Make sure you don’t squash your hands!
Do not open the protective cover of the halogen lamp whilst the device is in use.
You could be burnt!
Other information:
Do not pull on the power cable in order to remove the plug from the socket. Pull on
the plug directly.
Ensure that no damage occurs to the cable (e.g. sharp edges, high heat).
