6 Powering-up
bon SL-85
6 Powering-up
The slit lamp can be supplied with electricity by the mains connection or via an examination
unit.
a) Mains adaptor:
GA bon SL-85 Rev 1.0 E 211005.doc
12/20
(2) Focussing light connection
(1) Mains connection and fuses
(3) Slit lamp connection
(4) Protective earth connection
(5) Dimmer switch
(6) Problem indicator
(7) Power switch
Diagram 6-1: Mains connection- back Diagram 6-2: Mains connection front
1. Plug the slit lamp into connection (3).
2. Plug the focussing light into connection (2) (optional).
3. Earth the slit limp to connection (4).
4. Plug the mains adaptor (1) into the mains socket using the power cable.
5. Press the on/off switch.
The slit lamp is now ready for use. You can change the brightness of the lamp using the
dimmer switch (5).
b) Electricity via an examination unit
Only an expert must install the slit lamp to an examination unit. In particular, please ensure
that the supply voltage and power meets the requirements (see chapter on Technical data).
Use the appropriate operating controls on your examination unit to power the slit lamp.
