4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com
SAFETY INSTRUCTIONS
Warning: When using electric tools always follow basic safety
precautions to reduce the risk of fire, electric shock and
personal injury.
1. KNOW YOUR POWER TOOL. Read this manual carefully
and the drill manual associated with the drill used with this
Quickpoint Drill-Mate Mortar Gun.
2. Do not put hands in hopper while tool is plugged in.
3. Do not tighten or install parts while tool is plugged in.
4. Do not use the water hose to clean tool. (see cleaning
instructions)
5. In the event that tool plugs or jams, do not continue to
operate tool. See trouble shooting.
6. Before operating tool, be sure nozzle Key Allen Wrench is
inserted and lokcing nozzle in place.
7. Do not use this tool to dispense materials other than water
based cementacious mortars.
8. Do not overreach. Keep proper footing and balance at all
times.
9. Do not abuse power cord. Never carry tool by the drill
cord.
10. Keep hands away from all moving parts. (Install cam
guard before using)
11. Store idle tool. When not in use, store your tool in a dry
secure place. Keep out of the reach of children.
ACCESSORIES
• 1 - Angled steel tip no. 552-A
• 1 - Wide steel tip. 552
• 1 - Narrow steel tip no. 551
• 1 - Large steel tip no. 553
• 2 - “U” blades
• 3 - Tip blade sets
• 2 -
1/4
- 28 x
1/4
Stainless steel set screws
• 1 - Extra nozzle key Allen wrench
• 1 - 16 oz. Scoop no. 554
• 1 - 8 oz. Gibco’s - MRF
Tip blades can be made from 1/8” electrician’s snake.
Bend with pliers and vice to contour below or send for
replacement tips.
A set consists of one long, one short blade and on “U” blade.
<-- Insert this end in blade coupling.
Caution: Protect eyes when cutting
hardened wire.
NOZZLE ASSEMBLY
1. Drop metal nozzle tip into nozzle tip holder. Then insert
retaining collar as shown.
2. Slip the assembly over the front barrel of the gun. Pull the
nozzle assembly firmly against the front face of the gun
barrel until the metal nozzle tip is seated tightly in the
nozzle holder.
3. Insert the allen wrench key into the holes at the back of the
nozzle assembly. The allen key, when properly placed,
will fit in the slot at the back of the second o-ring.
Note:
The nozzle assembly can now
be rotated for vertical or horizontal
applications. When assembling,
make sure all mating surfaces are
clean to insure proper seating. Put
lubricant such as Vaseline on o-ring
area and area where Allen Key runs.
AUGER ASSEMBLY
1. Install the Blade-Coupling (#502) on to the Auger by
tightening the Socket set screw on the flat of the auger
shaft.
2. The short leg of the U-Blade (#504) is inserted between the
Tip-Blade-Set (#503) with the short-blade above (so that the
set screw tightens on this blade first) and the long blade
below.
1
INSTRUCTIONS
#14-188 Quickpoint
4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com
IS14188 08/09
PAGE 1 OF 4
