Bomar Ergonomic 320.250 GAC, Руководство по эксплуатации

Страница: 41 / 143

41
O
v
lá
d
á
n
í s
tr
o
je
B
e
d
ie
n
u
n
g
d
e
r M
a
s
c
h
in
e
M
a
c
h
in
e
c
o
n
tr
o
l
3.4.7. Ukon
č
ení servisního menu
Stiskn ě te tla č ítko F4. Tím servisní menu ukon č íte.
3.5. Band saw adjusting
3.5.1. Speed adjusting of the arm lowering
Set the speed of the arm lowering to the cut by control valve (position 16 –
control panel).
Set the lower speed of the arm lowering to the cut by turning the switch
clockwise.
Set the higher speed of the arm lowering to the cut by turning the switch
contra-clockwise.
3.5.2. Feeding length setting
Set the feeding length on the value, which is depicted on the screen – see
chapter Preset.
1. Release the securing lever of the feeding cylinder.
2. Set the desired length of the feed by hand wheel.
3. Tighten the securing lever of the feeding cylinder.
3.5.3. Cutting speed setting
Picture How to
1. Turn the switch 12 to the position „ “
(semi-automatic mode).
2. Use the frequency convertor 16 to adjust
requested speed of the saw band.
3.5.4. Angular cut setting
Notice:
If you keep closing the throttle valve too tightly, the valve
seat may wear off which causes its leakage. Therefore,
close the valve always gently.
"F1= mm(1) inch(0)[1]"
" "
" "
"<ZPET> <KONEC>"
F1 F 2 F3