18
Tips for Energy saving
Tips for Energy saving
Tips for Energy saving
Tips for Energy saving
•
Disconnect the appliance from the power supply,
if it isn’t in use.
•
Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
•
Ensure sufficient ventilation at the bottom and
rear side. Never block ventilation openings.
•
Do not adjust the temperature colder than neces-
sary.
•
Do not leave open the door for longer than re-
quired.
•
The appliance should be defrosted regularly.
•
Switch on the indoor light only if necessary.
•
The seal of the appliance door must be complete-
ly intact, so that the door closes properly.
Cleaning
Cleaning
Cleaning
Cleaning and Maintenance
and Maintenance
and Maintenance
and Maintenance
WARNING:
WARNING:
WARNING:
WARNING:
•
Always disconnect the appliance from the power
supply before cleaning and user maintenance.
•
Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of elec
Risk of elec
Risk of elec
Risk of electric shock!
tric shock!
tric shock!
tric shock! Hot steam could damage
the plastic parts.
•
The appliance must be dry before restarting oper-
ation.
CAUTION:
CAUTION:
CAUTION:
CAUTION:
•
Do not use a wire brush or other sharp, abrasive
items.
•
Do not use any acidic or abrasive detergents.
•
Do not damage the refrigerant circuit.
Cleaning the appliance including interior
Cleaning the appliance including interior
Cleaning the appliance including interior
Cleaning the appliance including interior
•
Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
•
Remove for that the appliance content and stor-
age at a cool location.
•
Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
•
After everything was thoroughly dried, you can
restart the operation.
Defrosting
Defrosting
Defrosting
Defrosting
CAUTION
CAUTION
CAUTION
CAUTION::::
Never use metal objects (e.g. knives) for removing
ice from the vaporizer. The vaporizer could be dam-
aged.
To achieve better cooling and to save energy, defrost
the device regularly.
•
To start the defrosting process, disconnect the
unit from the power supply.
•
Remove the loading and keep at a cool location
•
When the ice has melted, wipe the condensate
away and dry the appliance interior.
Changing the bulb
Changing the bulb
Changing the bulb
Changing the bulb
CAUTION:
CAUTION:
CAUTION:
CAUTION:
Do NOT
NOT
NOT
NOT remove the cover of the LED light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.
Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting
Before you c
Before you c
Before you c
Before you contact an authorized specialist
ontact an authorized specialist
ontact an authorized specialist
ontact an authorized specialist
Problem
Problem
Problem
Problem
Cause / Action
Cause / Action
Cause / Action
Cause / Action
Appliance is
not working
properly or
at all
-
Check the power supply / temperature
setting / ambient temperature.
-
Unblock the ventilation openings, install
the appliance freely.
Loading is
too warm
-
Check the temperature setting / ambi-
ent temperature.
-
Open the door only as long as neces-
sary.
