8
05/2013
Mumbling
Caused by the compressor during its operation. This is stronger
when it turns on or off.
Liquid sounds
Caused by the circulation of the refrigerant in the device.
Click sounds
The temperature control turns the compressor on or off.
Disturbing noises
Vibration of the shelves or cooling coils – check if those are se-
curely fastened.
Turning off
Turn the temperature to setting MIN in order to turn off the device.
If the device will not be operated for a longer period of time:
•
Remove the entire beverage from the device.
•
Turn the temperature control to setting MIN -.
•
Disconnect the plug or turn off / unscrew the fuse.
•
Thoroughly clean the device (refer to chapter of “Cleaning and Care”).
•
Keep the door open in order to prevent bad odors.
T
IPS
F
OR
E
NERGY
S
AVING
- Disconnect the plug if you do not use the device.
- Do not install the device near stoves, heaters or other heat sources. In case of higher ambient
temperatures, the compressor will run more frequently and longer.
- Ensure sufficient ventilation at the bottom and rear side of the device.
Never block any ventilation openings.
- Allow warm beverages to cool down before putting them in the device.
- Do not open the door longer than necessary.
- The device should be defrosted regularly.
- Make sure the door sealing is in good order for the door to close properly.
M
AINTENANCE
A
ND
C
LEANING
Cleaning and Care
For hygienic reasons, clean the interior and accessory parts regularly.
WARNING:
- Always disconnect the plug or turn off/ unscrew the fuse before cleaning. Pull the plug and not the
cable.
- Do not use steam cleaners for cleaning the device; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage the plastic parts. The device must be dry before
restarting operation.
- Essential oils and organic solvents, such as the juice of lemon or orange skin, butanoic acid or
cleaning agents containing acetic acid can damage plastic parts. Prevent contact of any part with
such substances. Do not use abrasive cleaning agents.
Please do as follows:
- Remove all drinks/beverages and keep at a cool location.
- Use warm water and a mild detergent for cleaning the interior (including rear side and bottom).
- After thorough drying, restart operation.
WARNING:
- Do not bend the cooling coils.
- Do not use arenaceous abrasives.
Changing the bulb
1. Before carrying out the bulb replacement always press and turn the
thermostat control dial to Position MIN, then disconnect the mains sup-
ply.
2. Hold and unscrew the light bulb cover.
3. Remove the plastic light bulb cover