BOMANN KSE 7805, Инструкция по эксплуатации

Страница: 21 / 28

21
4
4 4
4 5
5 5
5
6 6 6 6 7 7 7 7
8 8 8 8
1111 Install the power cord so that the appliance can be
easily connected after installation. Slide the appli-
ance into the build-in opening until the stop plate (A)
abuts the furniture.
2222 Press the rubber seal between the appliance and
built-in furniture firmly (on the side without hinge).
3333 Open the appliance door. Push the appliance side,
which is located opposite the hinges, against the
built-in furniture. Arrange the appliance for a secure,
vertical position, fix it with the supplied screws (S).
4444 In consideration of the shown distances, hold the
guide (a) at the top and bottom inside of the furniture
door; mark the positions of the drill holes. After drill-
ing, fix the guide with the screws (S) provided.
5555 Insert the cover (c) until it clicks in the guide (a).
6666 Fully open the appliance and furniture door and join
them together. Slide the angle (b) in the guide (a)
and mark the drill holes. Remove the bracket and
drill Ø 2 mm holes with about 8 mm distance to the
outer door edge. Put the bracket on again; secure it
with the screws (S) provided.
7777 If an aligning of the furniture door is necessary, use
the slot spacing. Check if the door is arranged verti-
cal as well as horizontal, so that a smooth opening
and closing of the door is ensured.
8888 Insert the cover (b) until it clicks on the angle (b).
Startup / Opera Startup / Opera Startup / Opera Startup / Operation tion tion tion
Prior to first use
Prior to first use Prior to first use
Prior to first use
CAUTION
CAUTION CAUTION
CAUTION::::
After transport, the appliance should be left standing
upright for about four hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter “Cleaning and Maintenance”.
Starting the appliance Starting the appliance Starting the appliance Starting the appliance
•
Connect the appliance to the power supply.
•
Operate the temperature control. See also the
section "Settings".
Settings
Settings Settings
Settings
Setting [ 0 ] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [ 1 – 7 ] regulate the different val-
ues of the internal temperature.
Setting 0 Setting 0 Setting 0 Setting 0 Setting 1 Setting 1 Setting 1 Setting 1 Setting Setting Setting Setting 7777
Off state Lowest setting
(warmest inside
temperature) Highest setting
(coldest inside
temperature)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a