BOMANN KSE 337, Руководство пользователя

Страница: 20 / 28

20
The ventilation openings in the furniture base and
building must be min. 200 cm
2
to ensure that heated
air can freely escape.
Install the power cord so that the appli-
ance can be easily connected after
installation. Slide the appliance into the
build-in opening until the stop plate (A)
abuts the furniture.
Press the rubber seal between the
appliance and built-in furniture firmly
(on the side without hinge).
Open the appliance door. Push the
appliance side, which is located oppo-
site the hinges, against the built-in
furniture. Arrange the appliance for a
secure, vertical position, fix it with the
supplied screws and put the protective
cap (B) on.
Separate the parts b, c and d of part a.
In consideration of the shown distanc-
es, hold the guide (a) at the top and
bottom inside of the furniture door; mark
the positions of the drill holes. After
drilling, fix the guide with the screws
provided.
Insert the cover (c) until it clicks in the
guide (a).
Fully open the appliance and furniture
door and join them together. Slide the
bracket (b) in the guide (a) and mark
the drill holes. Remove the bracket and
drill Ø 2 mm holes with about 8 mm
distance to the outer door edge. Put the
bracket on again; secure it with the
screws provided.
If an aligning of the furniture door is
necessary, use the slot spacing. Check
if the door is arranged vertical as well
as horizontal, so that a smooth opening
and closing of the door is ensured.
Insert the cover (D) until it clicks on the
angle (B).
Startup / Operation Startup / Operation Startup / Operation Startup / Operation
Prior to first use
Prior to first use Prior to first use
Prior to first use
CAUTION CAUTION CAUTION CAUTION::::
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter “Cleaning and Maintenance”.
Starting the appliance Starting the appliance Starting the appliance Starting the appliance
•
Connect the appliance to the power supply.
•
Operate the temperature control. See also the
following section "Settings".
Settings Settings Settings Settings
Setting [0] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [1–7] regulates the different values
of the internal temperature.
Setting 0 Setting 0 Setting 0 Setting 0 Setting 1 Setting 1 Setting 1 Setting 1 Setting 7 Setting 7 Setting 7 Setting 7
Off state Lowest setting
(warmest inside
temperature) Highest setting
(coldest inside
temperature)