BOMANN GSPE 7414 TI, Инструкция по эксплуатации

Страница: 8 / 24

8
Water connection
CAUTION:

The Installation of the water supply must conform
to the local laws and regulations.

The appliance is not suitable for hot water supply.

Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.

If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.
Notes on inlet hose safety system
(delivery scope depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop,
www.bomann-germarny.de . To order, use the
reference number found under “Technical Data”.
Connect the water inlet hose (cold water connection)
NOTE:
The water pressure must be between 0.04-1.0 MPa.
With higher pressure: use a pressure regulator.

Connect the water inlet hose to a
water thread with ¾“. Screw the
hose firmly in the direction of the
screw thread; pay attention for a
tight fit.

Connect the other end of the inlet
hose to the inlet valve on the ap-
pliance back; pay attention for a
tight fit too.
Connect the water drain hose
NOTE:
The drain hose has a length of approx. 1.5 m and
can extend with a suitable hose and connecting
piece to a length of max. 4 m.
CAUTION:
In order to prevent backflow of contaminated water,
the free end of the hose must not come under the
water level of the drain.

Connect the drain hose to a drainpipe (B) with a
minimum diameter of 40 mm; alternatively, the
drain hose can be fixed directly to the sink (A).

Always make sure that the hose is not bent or
squeezed.

The drain hose may only install maximal up to a
height of 1000 mm above the rinsing floor.

Secure the drain hose securely to avoid a change
in position and with it a water leakage.
Electrical connection
WARNING:

The installation to the mains supply must conform
to the local standards and regulations.

Improper connection may cause to an electric
shock!

Do not use multiple sockets or extension cords.

It is not allowed to modify the plug provided with
the appliance! If the plug does not fit properly to
the outlet, let install a proper outlet by an author-
ized specialist.