BOMANN DT 349, Инструкция по эксплуатации

Страница: 20 / 28

20
13. Fix the top hinge on left side of the cover, and out
the plastic cover of step 10 to cover the hole on
right side of the cover.
14. Fix the bottom hinge on left side of cabinet.
15. Put the doors fixed into hinge pins and screw the
middle hinge on left side of middle.
16. Screw the cover and put the covers back, and
check if the doors are aligned vertically and hori-
zontally optimally so that the smooth opening and
closing of the doors is quaranteed.
Startup / Operation
Startup / Operation Startup / Operation
Startup / Operation
Prior
Prior Prior
Prior to first use
to first use to first use
to first use
CAUTION
CAUTION CAUTION
CAUTION::::
After transport, the appliance should be left standing
upright for about 4 hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter “Cleaning and Maintenance”.
Starting the appliance Starting the appliance Starting the appliance Starting the appliance
•
Connect the appliance to the power supply.
•
Operate the temperature control. See also the
following section "Settings".
Settings Settings Settings Settings
Setting [0] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [1–6] regulates the different values
of the internal temperature.
Setting 0
Setting 0 Setting 0
Setting 0 Setting 1
Setting 1 Setting 1
Setting 1 Setting
Setting Setting
Setting 6666
Off state Lowest setting
(warmest inside
temperature) Highest setting
(coldest inside
temperature)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
medium setting; correcting the temperature at a later
point would then be easier.