21
Tilt the appliance slightly back and block it in this po-
sition. Use the delivered screw to secure the support-
ing pad into the hole provided on the underside of the
door.
Leveling the appliance
Slight unevenness in the floor can be leveled out us-
ing the front feet.
Check whether the appliance is leveled horizontally.
If the appliance is not in balance, the feet must be
adjusted.
Electrical connection
WARNING:
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric
shock!
•
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
•
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
•
Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
•
Ask another person to assist.
•
You possibly need:
screw wrench, Phillips screw-
driver as well as a thin-blade screwdriver.
•
Loosen the screws on the appliance back and re-
move the appliance cover.
•
Dismount the upper door hinge and the screws
(s). Lift the appliance door and set it safely aside.
•
Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet and disassemble
the lower door hinge.
•
Transfer and attach the lower door hinge to the
opposite appliance side. Screw in the feet accord-
ingly.
•
Put the appliance back in the upright position.
Put on the appliance door and fix it its intended
position.
•
Transfer and attach the upper door hinge to the
opposite appliance side after unscrewing the