RATCHET WHEEL
PAWL
DRIVE PLATE PIN
CONNECTING ROD
SPRING SEAT
F
= USE LUBRICATION
IN THIS AREA WITH
MOLYCOTE PASTE
20
QD4 DRIVE PLATE ASSEMBLY
22
21
85
18
85
24
23
ASSEMBLY INSTRUCTIONS
INSERT PAWL (21) INTO RIGHT-SIDE DRIVE PLATE (19).
1.
PLACE RATCHET WHEEL (22) INTO THE DRIVE PLATE.
2.
**NOTE: THE DIRECTION OF THE MESHING TEETH OF THE PAWL AND RATCHET WHEEL
MUST BE AS SHOWN IN DIAGRAM 2A.
INSERT PAWL SPRING (20) INTO THE POCKET IN THE RIGHT SIDE DRIVE PLATE.
3.
SLIDE THE LEFT SIDE DRIVE PLATE ONTO THE RATCHET WHEEL HUB.
4.
THE DRIVE PLATE PIN (24) CAN THEN BE INSERTED IN EACH OF THE DRIVE PLATES.
5.
PLACE THE RETAINING RINGS (23) ON THE DRIVE PLATE PIN.
6.
THIS WILL HOLD THE DRIVE PLATE ASSEMBLY TOGETHER.
**NOTE: ONCE ASSEMBLED, ONE SHOULD BE ABLE TO ROTATE THE RATCHET WHEEL WHILE
HOLDING THE DRIVE PLATES STATIONARY. REVERSE ROTATION OF THE RATCHET WHEEL
SHOULD TURN THE ENTIRE ASSEMBLY, WHICH WOULD INDICATE THE TEETH ARE MESHING
PROPERLY. IF EITHER OF THE BEFORE-MENTIONED IS NOT THE CASE SOMETHING IS
IMPROPERLY ASSEMBLED.
CUSTOMER:
D
C
B
A
A
B
C
D
1
2
3
4
5
6
7
8
8
7
6
5
4
3
2
1
HEAT TREAT
UNLESS OTHERWISE SPECIFIED:
ZONE
APPROVED
PERMISSION OF BOLTTECH IS PROHIBITED.
PROPRIETARY AND CONFIDENTIAL
OR AS A WHOLE WITHOUT THE WRITTEN
BOLTTECH. ANY REPRODUCTION IN PART
DRAWING IS THE SOLE PROPERTY OF
THE INFORMATION CONTAINED IN THIS
THREE PLACE D/- 0.005
MATERIAL
FINISH
DRAWN
CHECKED
ENG APPR.
MFG APPR.
Q.A.
DATE
NAME
TITLE:
SIZE
B
DWG. NO.
REV
SHEET 6 OF 18
WEIGHT:
SCALE: 1:4
REVISIONS
REV.
DESCRIPTION
DATE
DIMENSIONS ARE IN INCHES
FRAC/- 1/32"
ANGULAR: +/- 1/2 DEGREE
TWO PLACE DECIMAL +/- 0.01
SOFTWARE: SOLID WORKS
DRIVE PLATE
24
PAWL SPRING
DRIVE PLATE PIN
DRIVE PLATE
19
DRIVE PLATE
CONNECTING ROD
21
PAWL
22
RATCHET WHEEL
PIN SNAP RING
SPRAY WITH
MOLYLUBE
DIAGRAM 2A
