BN-NVRM4POE Manual Bolide Technology Group, Inc
iii
Conform to local electrical safety standards and use power adapters that are
marked with the LPS standard when installing and using this device. Otherwise,
this device may be damaged.
Use the accessories delivered with this device. The voltage must meet input
voltage requirements for this device.
If this device is installed in places with unsteady voltage, ground this device to
discharge high energy levels (such as electrical surges) in order to prevent the
power supply from burning out.
When in use, ensure that no liquids flow into the device. Immediately power off the
device and disconnect all cables if water, or any other liquid, unexpectedly flows into
the device.
Do not focus strong light (such as light bulbs or sunlight) on this device.
Otherwise, the service life of the image sensor may be shortened.
If this device is installed in places where lightning frequently occurs, ground the
device to discharge high energy levels, such as lightning strikes, in order to
prevent device damage.
Avoid heavy loads, intensive shakes, and soaking to prevent damages during
transportation and storage. The warranty does not cover any damage that is caused
during secondary packaging and transportation after the original packaging is
taken apart.
Protect this device from dropping or significant impact. Keep the device away from
magnetic field interference. Do not install the device in places with shaking
surfaces or frequent rattling.
Clean the device with a soft and dry cloth. For stubborn stains, dip the cloth into
a neutral cleanser, and then gently wipe the stain away with the cloth before you
dry the device.
Do not jam or block the ventilation opening. Follow the installation instructions
provided in this document when installing the device.
Keep the device away from heat sources such as radiators, electric heaters, open
flame, and other heating equipment.
Keep the device away from places that are moist, dusty, extremely hot,
extremely cold, or contain strong electric currents.
If the device is installed outdoors, take measures to repel insects and moisture
to avoid circuit board corrosion that can affect monitoring.
Unplug the power plug if the device has been idle for a long time.
Before unpacking, check to see if the fragile sticker is damaged. If the fragile
sticker is damaged, contact the customer service or sales personnel. The
manufacturer shall not be held responsible for any artificial damage to the fragile
sticker.
