Assembly
1.
Place
A
on a flat stable surface.
2.
Insert
C
into slot with short edge up.
3.
Place
B
onto
C
. Insert two screws and tighten slightly using the Allen key. Repeat for the other side.
4.
Insert one
G
into slot at the back. Insert a screw and tighten slightly. Repeat for the other side.
5.
Insert
D
into the slot. Insert a screw and tighten slightly. Repeat for the other side.
6.
Slide
E
through the loop of the crotch strap. Insert
E
into slot. Insert a screw and tighten slightly.
Repeat for the other side.
7.
Insert
F
into slot. Insert a screw and tighten slightly. Repeat for the other side.
8.
Insert second
G
into slot at the front. Insert a screw and tighten slightly. Repeat for the other side.
9.
Tighten all screws.
10.
Turn chair upside down and attach waist strap and crotch strap with washers and small screws to the
underside of the seat (as shown).
Compliance
BOLERO parts have undergone strict product testing in order to comply with regulatory standards and
specifications set by international, independent, and federal authorities.
This product conforms to: BS EN 14988: 2006: Parts 1 and 2
BOLERO Telephone Helpline: +44 (0)845 146 2887
BOLERO, Fourth Way, Avonmouth, United Kingdom, BS11 8TB
Note: During assembly, ensure that all screws are only loosely connected. Tightening
the screws as you go will make assembly difficult.