Assembly Instructions : Page 6
Step 14
Glue one of the “tilt plates” to the body end with its foot
resting of the chassis top. Repeat for the other end noting
that both plates should be leaning towards the door.
Step 15
Super glue a coupling hook into the hole in the dumb
buffer. (You will probably have to clean out the hole first by
“twiddling” a 1.5 mm twist drill through it).
Repeat at the other end.
Step 16
Finally push one wheel onto an axle, pass the axle through a bearing tube in the chassis and fit
another wheel to the other end. Gently squeeze the two wheels together in smooth jawed vice until
the “back to back” distance is 28 mm. NB a back to back gauge is provided in the kit to help get this
right.
Repeat for other axle
Job Done!