Boldan Oy, Matkuntie 3, FIN-05200 Rajamäki |
www.boldan.fi
| +358 (0)9 853 1042
MANUAL
Extruder ProSeries 550
6
Connect the water hose, which will go inside the
liner, onto the drum’s quick connector. Wind the
water hose neatly around the shaft. You can
use the water hose as a liner feeding string by
attaching it to the liner knot.
Connect the water inlet to the quick connector on
the drum crankshaft. Once the liner has been shot
and pressurized into the pipe, you can start feeding
warm water into the liner’s end. The regulator
releases the pressure as the liner fills with water.
When the water reaches the drum, you can start
the water cycle by letting water out through the
bottom valve while warm water enters the liner’s
end.
Necessary parts for the water connection.
5.
6.
7.
