Use of the control
5.2
Compressed airnet view
Page 38
BOGE compressor control airtelligence provis 3
ponents at the beginning of the installation of a network and at any time after-
wards, so that they always correspond to the real conditions, see also
„Change arrangement of components in DIN and 2D representation“.
Status display: 2D repre-
sentation
The 2D representation can be called up by tapping the 2D button. This form of
representation corresponds to the DIN representation, but more pictorial two-
dimensional symbols are used instead of the operating status symbols for the
components:
Fig. 5.4: Compressed airnet view: 2D representation
In this form of representation it is also possible to change the connection and
arrangement of the components at the beginning of the installation of a net-
work and at any time afterwards, so that they always correspond to the real
conditions, see also „Change arrangement of components in DIN and 2D rep-
resentation“.
Status display: 3D repre-
sentation
The 3D representation can be called up by tapping the 3D button. In this rep-
resentation form, the compressed airnet is displayed three-dimensionally and
according to the arrangement as set up in the DIN or 2D representation:
Fig. 5.5: Compressed airnet view: 3D representation
