BOFI XLT TS Series, Руководство по обслуживанию

Страница: 15 / 37

XLT TS Series Service Manual
15
Barber Colman 7SC Programming Procedure
To switch display from F° to C°, see instructions at the end of this section.
1) Remove the instrument from its case and put the V101 switch in the open
position. The V101 switch is located on the bottom of the unit. Verify that
jumper J106 is:
1-2 3-4 5-6 7-8 9-10
Open Closed Open Open Open
The J106 jumper is located on the top of the unit. Insert the instrument back
into the case.
2) Turn on the power to the unit by switching the fan on. The display should
show COnF; press the FUNC key to step through the configuration parameters.
3) The following configuration parameters should be entered/verified (Use the
Up/Down keys to change the values if necessary):
Ser1 0FF P7 --
Ser2 1 P8 --
Ser3 19.20 P9 AL1.P
Ser4 7E P10 H.A.
P11 nonE
P1 22 P12 --
P2 -- P13 --
P3 0 P14 --
P4 600 P15 --
P5 rEU P16 0
P6 4-20 P17 SFt.A (3111)
4) The Display should now show: -.-.-.-. Press the Up/Down keys to display
262, and then press the FUNC key to access the advanced configuration.
5) The following advanced configuration parameters should be entered/verified
(Use the Up/Down keys to change the values if necessary):
P18 norL P32 1.0
P19 norL P33 0.20
P20 -- P34 0FF