Bodyworx JX200, Руководство пользователя

Страница: 12 / 18

11
** When the SAFETY KEY is taken off and then replaced, the treadmill will not reposit from
any position it is. You need to press start key to perform the reposition.
** When the power is on, the treadmill will not reposit from any position it is. You need to
press start key to perform the reposition.
** Under start/ready status, press stop key for 5 seconds, the treadmill will reposit from any
position it is.
**During performing any program, by press stop key, the program will stop. If users want to
resume to the program, press start key or press stop key again to leave the program and back
to start/ready status.
MODE
Function key
5. Under start/ready mode, press and
MANUAL
LED will flash, which means into
function selection mode. Under this mode, press
“
or
＂
to switch
MANUAL
、
P1~P5 and HRC LED light.
6. MANUAL function
：
6.1. When
MANUAL
LED is flashing, press and the
MANUAL
LED will stop
flashing and keep light.
TIME
LED will flash, at this time you can adjust the time.
6.2. Press and the motor will start with a speed of 1.0km/hr , at this time press
“ or ” to control the incline angles and the speed of the treadmill.
7. P1~P5 Program Control Function (each PROGRAM has 12 segments)
7.1. When the
MANUAL
LED begin to flash, you can press “ or ” until
the desired LED of
P1~P5
begin to flash, press to confirm, after you enter the
program control function, the corresponding light will keep on lighting.
7.2. At this time, the
CALORIES
window will display the exercise intensive
level( L1~L5 ) you can press
“
or
＂
to select the desired level and
press to co nfirm.
7.3. After the level is selected, the TIME window flashes, at this time you can press
“
or
＂
to change the time, after the desired time is set, press
to confirm and the
TIME
window will stop flashing.
** Time preset value
：
25(min)