Bodyworx JTM2500, Руководство пользователя

Страница: 26 / 27

26
Error Code Error Code Description Fault Processing
E01
Communication
abnormal: The inverter
and computer has
abnormal communication
after start
1
.
Check if the computer is connected with the inverter well, or
any damages of the lines.
2. Check the inverter and c hange it if it is damaged.
3. Check the computer and change it if it is damaged.
E02
The motor wire is not
connecting well
1.
Check if the motor wire is connected well and re-connect the motor
wire.
2. Check if there is a burn ing smell for controller, if yes, please
change the controller.
E03
Current overload
Protection
1.
Stop and go into fault status, computer buzzle will ring 3 tones and
shows fault code“E3”. Other areas show blank. After 10 seconds will go
into ready mode, and can restart.
2. Possible Reasons
：
Over the rated load cause too much electricity that
make system s elf-preservation or some parts blocked and DC motor
can’t process. Adjust the machine and restart.
3.
Another please check the DC motor or controller have any burn
ing
smell or not. If yes, please change the motor or controller. M ake sure the
power and voltage compl
ies
with standard
s
.
E06
Explosion-Proof
Protection
:
Some
unusual condition of
power or voltage that
cause damage to the
motor drive circuit.
Check if there is a burn ing smell for controller, if yes, please change the
controller.
Possible Reasons
：
The power voltage is less than normal or the
controller has some problems. Make sure the motor wire is connecting
well.
—
—
Computer doesn’t
detect safety key signal
1.Check if safety key switch works, connecting wire works, or magnet
inside works.
2.Safety key is not placed correctly.
3.Safety key is damaged.
No display on
computer
No power
1
.
C heck if power cable is connected to machine or change to another
power outlet. If power switch is in position, test it by switch
ON/OFF. If the power switch is burned out, replace one and make
sure there’s power to machine
.
2
.
Check cable connection between computer and inverter
.
3
.
Replace adaptor or computer
.
Error code and significance